Issues with using quads as pinning site

[Dt450]

It’s been strange because the last 4-6 times spread out from different cycles I’ve injected in my quad and it gets very swollen. As well as being painful to the point I can barely bend my leg.
I’ve done it numerous times in the past with no trouble but now it’s like I have a systemic reaction whenever it’s shot into the quad. Takes about a week to recover. Upper outer quadrant is the best place right? Could I just have too tight of quads to be injecting there?
Anyone have a clue of what it could be?

 

[thudgens96]

It’s been strange because the last 4-6 times spread out from different cycles I’ve injected in my quad and it gets very swollen. As well as being painful to the point I can barely bend my leg.
I’ve done it numerous times in the past with no trouble but now it’s like I have a systemic reaction whenever it’s shot into the quad. Takes about a week to recover. Upper outer quadrant is the best place right? Could I just have too tight of quads to be injecting there?
Anyone have a clue of what it could be?

I have gone through the same thing. It went away as strangely as the problem came about.

Sent from my SM-S975L using Tapatalk

 

[Anon44]

I can't pin quads anymore because of the same thing. It didn't happen everytime but it happened enough for me to stop hitting them.

 

[dustined83]

I only pin quads for years now and i never have problems unless i mess up the pinning or I'll get a little pip depending on compounds I'm takin and who made it

Sent from my LGMP260 using Tapatalk

 

[01dragonslayer]

Could be the solvents ratio used in the brewing process.

 

[Dt450]

Idk about solvent issue just because it wasnt just one cycle I had an issue on it.
it has happened from even just 1ML. After contemplating it could be the issue of me using 22g? I see a lot of other guys using 25g or smaller.
Idk maybe I need to revisit site injections on the quad. It was the last 4-6 times back to back that left me damn near crippled lol

 

[01dragonslayer]

Idk about solvent issue just because it wasnt just one cycle I had an issue on it.
it has happened from even just 1ML. After contemplating it could be the issue of me using 22g? I see a lot of other guys using 25g or smaller.
Idk maybe I need to revisit site injections on the quad. It was the last 4-6 times back to back that left me damn near crippled lol

IMO the gauge of needle really wouldn't have anything to do about. I've have used 21g and never had any isssues. With previous cycles even with the possibility of using different hormones if you purchased your gear from the same source and using the same brand I would most likely bet its the same brewer using the same ratio of BA/BB